Start your trial now! First week only $4.99!*arrow_forward*

Question

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: Write a short note for 100 words, why does voltage decrease when increasing a capacitance?

A: Assume a parallel plate capacitor. It's capacitance is given by the formula C=εoAd Here, A is the ar...

Q: primary lines exist in electrical post, wht is the range of voltage passing thru this part of the po...

A: The common primary range voltage in the primary line is 2,300,4,160, 12,470, 13,800, 25,000 in Volts...

Q: Discuss about Power Thyristor's DC and Ac switching.(with Diagram)

A: Power Thyristor DC circuit is as follows: - This basic "on-off" thyristor terminating circuit utili...

Q: The network in the Figure below operates at 60 Hz. Compute the energy stored in the mutually coupled...

A: Click to see the answer

Q: A salient-pole generator operates at rated conditions with a 0.8 PF lagging. It has Xd=1pu and Xq=0....

A: Write down the formula for armature voltage and power angle assume terminal voltage = 1 pu

Q: This question from Measurements instrumentation course.

A: Non linearity is used to represent the behavior or certain device and element. Non linearity occurs ...

Q: Please provide long discriptive answer on given topic. Topic : single phase half controlled rectifie...

A: Single-phase half controlled rectifier fed DC series motor:- Single-phase controlled Rectifier Contr...

Q: For the circuit shown in Figure, determine the power absorbed by the 5 ohm resiston ww 20 V ( ww

A: As all the elements are connected in series, considering the current flowing in the circuit is i, Re...

Q: Source Transformation

A: Given two circuits which are equivalent to each other due to a source transformation Source transfo...

Q: For a on junction diode, what will be the thermal voltage (in milli volts) at 421 K?

A: Given information: The temperature is given as T=421 K The value of the thermal voltage for a pn jun...

Q: 6. Consider a continuous-time LTI system for which the input x(t) and output y(1) are related by dif...

A: Click to see the answer

Q: In the circuit given below, R = 45 Ω. Find the currents I1 through I4 and the voltage v0. The v...

A: Click to see the answer

Q: Graphs of current against voltage for two resistors P and Q are shown in Figure 4. Determine the val...

A: To determine the value of resistors from the graph This is tha graph drawn between current and volt...

Q: The purpose of a pentavalent impurity is to 1. Reduce the conductivity of semiconductor 2. Increase ...

A: Click to see the answer

Q: In the figure, SCR semiconductor switched rectifier to a 220 Vrms ac source at 50 Hz, at load Vdc = ...

A: we have to find (a) the total power absorbed by the load. (b) If the inductance value is 30 mH, the ...

Q: A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t 0, there ...

A: Click to see the answer

Q: Find the transmission parameters for the two-port network shown in the figure below. I1 jin I2 V1 キ4...

A: Click to see the answer

Q: A certain population of bacteria doubles in 2yrs. If in 3yrs there are 59,377 of bacteria present, h...

A: Given, a certain population of bacteria doubles in every 2 years. And, in 3 years the bacteria popul...

Q: Detailed circuit diagram of 8 bit DAC& Process explanations Calculation for binary inputs Calcu...

A: A digital-to-analog converter (DAC, D/A, D2A, or D-to-A) is a system that converts a digital signal ...

Q: Find the transmission parameters for the two-port network shown in the figure below. 4Ω j1 n I2 V1 V...

A: Given two-port network,

Q: Consider the generalized block diagram of an PLL. For any two stages of the block diagram ,consider ...

A: A phase locked loop (PLL) generates an output signal whose phase is related to the phase of an input...

Q: (1) A full adder in which: SUM = C' (AB' + A'B) +C (AB + A'B') (2) CY = AB + BC + AC

A: The truth table for the given full adder is given as A B C Sum Carry 0 0 0 0 0 0 0 1 1 0 0...

Q: Consider the given figure where V1 = 45 V and V2 = 40 V. Use source transformations to reduce the ci...

A: Click to see the answer

Q: Question:5 The full wave rectifier with filter is given, calculate: Do Filtered output V. "Drip-p) R...

A: The peak to peak ripple voltage is the difference between the maximum voltage and the minimum voltag...

Q: Design a sequential circuit with two D flip-flops A and B, and one input x_in . a) When x_in = 0, th...

A: a)

Q: please help, Design a common source (CS) amplifier to have a voltage gain of -25V/V when the drain c...

A: Click to see the answer

Q: All resistors (R) in the given figure are 15 Ω each. Find Req. The value of Req is _______ Ω.

A: Given all resistors are R=15 ohm

Q: What effect (increase or decrease) would the following changes have on the inductance of a coil?(Jus...

A: Click to see the answer

Q: Q2 and Q3 were collect. Please please help me.

A: To find the current through R4 and capacitor

Q: This question from Measurements Instrumetation course

A: Given: Rθ=αeβθ At θ1=273.15 K, R1=9 kΩθ2=373.15 K, R2=0.5 kΩ

Q: v Part 4: Complete Response of a 2nd Order Circuit X Incorrect. You will need to find the current th...

A: In the given circuit: Find v(t) for t>0 for the circuit when v(0)=4 V and il(0)=0 A: Draw the ci...

Q: In the circuit given below, R = 18 Ω. Find the value of v0 using nodal analysis. The nodal equation...

A: Given R = 18 Ω To write the nodal equation The nodal equations are: v1/ A + (v1 − 60)/B + C/20 = 0 ...

Q: In a lossless simple medium (€, = 9, µr = 1, o = 0), a uniform plane wave with E propagates in the +...

A: Given, ξr=9Ex0=10 V/mf=109Hz β=2πfξrc =2π×10993×108β=20π rad/secEx=Ex0 cos(ωt-βz)Ex=10 cos 2π×10...

Q: 4. Indicate if the power thyristor will be on or off under the following conditions: The thyristor w...

A: Click to see the answer

Q: Sketch vo for the given network and determine the dc voltage available

A: Click to see the answer